LEXMARK OPTRA S 1855 DRIVERS FOR MAC DOWNLOAD

Replace bump motor Replace interlock switch Replace System Card. The pin should enter the tower on the HVPS and depress the cover switch. Install Transfer Drum Unit. Shop for Lexmark print cartridges. Check connections to the to interconnect card assembly. Serial Error – Framing or parity error on serial.

Uploader: Kagami
Date Added: 11 August 2005
File Size: 48.28 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 10808
Price: Free* [*Free Regsitration Required]

Los Altos Hills, CA. The heated roller is heated lexmark optra s 1855 a halogen lamp or in some cases a solid e ceramic heating element and is subject to failure. Check the TMC pin in the cartridge contact error for free non binding movement. Can also be LVPS or system board. Replace the assys in the following order 1.

Lexmark Printer Drivers by Model

Remove the duplex front cover to access the jam area. The toner sensor is not operating properly, the developer drive assembly is optrra operating properly or the print cartridge is defective.

Page too complex to print. The wrong printhead is installed.

Lexmark Printer Drivers

Open the printer rear door to access the jam. The defined paper size is too short to print data as formatted. Erase lamp assembly missing or disconnected. A error caused by low line voltage can sometimes be cleared by turning the machine off and then on again.

Support | Lexmark

Error Error Pay close attention to the area where the toner cartridge sits. Error 82 Photo Developer Cartridge Exhausted. Disk Full Not enough disk space for data that has been requested to be written to disk. Replace System Board Request Quote. Any help here would be appreciated too. Printhead Lexmatk – May have sub-codes. The main motor is located just to the left of the toner cartridge. If one of these errors appeared during POST, or while the printer was idle not printing or receiving datalexmark optra s 1855 while trying to print lexmark optra s 1855 of the internal test pages, replace the system board.

Related Driver:  ASUS P4SP-MX SE DRIVER

Motor bump aligner service check 1.

Thank you and your firm again, you were terrific. Replace the transfer roller as necessary. Check connections to the to interconnect card assembly.

Press “GO” to optda message and temporarily continue. Indicates that the fuser is below standby temperature when the printer is idle. Check the continuity of the fuser oprta at the two heavy leads.

Replace the Lexmark optra s 1855 Assy. Roller is approximately 2″ in circumference print defects with this repetitive spacing can be caused by transfer roller lexmark optra s 1855, on a standard 11″ page defect would repeat five times. System Board Pricing Request Quote. Try opening Tray X. This error indicates the printer was able to read the cartridge ID, but the ID did not pass the verification test.

Check the wiring harness cable.

Jam at the duplex unit. Check fan for binding or defective bearing – Replace Fan How did we do?

Page Not Found

Flash Full – Not lexmark optra s 1855 flash memory for data requested to be stored. If pin does not move freely you may need to replace the contact assembly. Also, if the accumulated sheets are removed, the portion of the job printed after the jam will not be stapled.

The fuser is the main part of a printer maintenance kit. Thank you for the speedy shipment and response. Fuser Pricing How did we do? Great that you have that part in stock and thank you for your quick reply. We got it this morning and I have it installed. No inkjet error codes available Error Code.

Defective font card lexmark optra s 1855 in font slot.